Editing Snap-O-Lantern Kit Assembly Instructions
Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.
The edit can be undone.
Please check the comparison below to verify that this is what you want to do, and then save the changes below to finish undoing the edit.
Latest revision | Your text | ||
Line 28: | Line 28: | ||
http://shop.emscdn.com/wiki/snapolantern/2.jpg | http://shop.emscdn.com/wiki/snapolantern/2.jpg | ||
− | You have two pairs of wires, and two orange LEDs. Solder the long lead of the LED to the lighter wire, and the short | + | You have two pairs of wires, and two orange LEDs. Solder the long lead of the LED to the lighter wire, and the short leg to the darker one. Your wire pair colors may vary, but here, the yellow wire goes to the long lead and the blue one to the short lead. You can trim both the leads (as shown), or leave one long to stick into the top of the pumpkin. |
+ | |||