Editing AYAB Mac Installation
Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.
The edit can be undone.
Please check the comparison below to verify that this is what you want to do, and then save the changes below to finish undoing the edit.
Latest revision | Your text | ||
Line 4: | Line 4: | ||
Note that as mentioned in the 'Getting Started' section, Mac users will need to install the [http://www.silabs.com/products/mcu/pages/usbtouartbridgevcpdrivers.aspx SiLabs CP210x "VCP" Drivers] before the AYAB software will be able to "see" the interface board. | Note that as mentioned in the 'Getting Started' section, Mac users will need to install the [http://www.silabs.com/products/mcu/pages/usbtouartbridgevcpdrivers.aspx SiLabs CP210x "VCP" Drivers] before the AYAB software will be able to "see" the interface board. | ||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
Thanks to Christoph (@chs_sch), who built a DMG of the AYAB software v0.8. | Thanks to Christoph (@chs_sch), who built a DMG of the AYAB software v0.8. |