Difference between revisions of "Eggbot Quality Troubleshooting"

From Evil Mad Scientist Wiki
Jump to: navigation, search
Line 32: Line 32:
  
 
=== Alignment of the egg in the egg cups ===
 
=== Alignment of the egg in the egg cups ===
 +
http://shop.emscdn.com/wiki/eggbot/quality/15A.jpg
 +
  
 
=== Loose screws ===
 
=== Loose screws ===
 +
http://shop.emscdn.com/wiki/eggbot/quality/17A.jpg
 +
 +
http://shop.emscdn.com/wiki/eggbot/quality/18A.jpg
 +
 +
http://shop.emscdn.com/wiki/eggbot/quality/19A.jpg
  
 
=== Vertical position of the pen motor ===
 
=== Vertical position of the pen motor ===
 +
http://shop.emscdn.com/wiki/eggbot/quality/9A-1.jpg
 +
 +
http://shop.emscdn.com/wiki/eggbot/quality/10A-1.jpg
  
 
=== Headstock / Tailstock position ===
 
=== Headstock / Tailstock position ===

Revision as of 11:12, 11 July 2014

If you are having quality issues with your prints that might be due to a misalignment of some sort, we hope that this guide will help you to find the source of the problem. This guide contains some helpful pictures that show how configuring the EggBot in different ways can produce different outcomes.


"Hardware" issues

Our test file

1A.jpg

This is the test file that we'll be using for our examples. Note that the print quality is fine and consistent. The "O's" have closed shapes, the vertical parts are vertical, the horizontal parts are horizontal, the slants of the "W's" have consistent width, and so forth. (Some of the examples that we'll show later do not have these properties!)

You can download the example file here. (TODO: ADD LINK)

This was printed with the Deluxe EggBot on a chicken egg with an Ultra Fine Point Sharpie. The egg was oriented with its "fat" side pointing towards the egg motor (headstock).

The print settings were as follows:

  • Timing tab:
    • Speed when pen is down: 300 steps/s
    • Speed when pen is up: 400 steps/s
    • Pen raising speed: 50 %/s
    • Delay after raising pen: 200 ms
    • Pen lowering speed: 20 %/s
    • Delay after lowering pen: 400 ms
  • Options tab:
    • Reverse motion of Motor 1 (pen): checked
    • Reverse motion of Motor 2 (egg): checked
    • Egg (x) axis wraps around: checked
    • Start with pen centered: checked
    • Return home when done: checked
    • Enable engraver, if attached: unchecked
    • Curve smoothing (lower for more): 0.2

Alignment of the egg in the egg cups

15A.jpg


Loose screws

17A.jpg

18A.jpg

19A.jpg

Vertical position of the pen motor

9A-1.jpg

10A-1.jpg

Headstock / Tailstock position

Pen arm backer position

"Software" issues

Motor reversal issues

Timing issues