Editing Octolively-IGoL Conversion
Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.
The edit can be undone.
Please check the comparison below to verify that this is what you want to do, and then save the changes below to finish undoing the edit.
Latest revision | Your text | ||
Line 4: | Line 4: | ||
'''Hardware''' | '''Hardware''' | ||
− | The principal hardware difference between the kits is that the IGoL kit is provided with a [http:// | + | The principal hardware difference between the kits is that the IGoL kit is provided with a [http://evilmadscience.com/productsmenu/partsmenu/144-xtlcaps 16 MHz crystal] (and two helper caps). To convert an Octolively board into an IGoL board, begin by adding these three components in locations XTL, C5, and C6. No hardware changes are needed to convert an IGoL kit to Octolively. |
− | You will also need the correct hardware to reprogram the boards. If you do not have a [http:// | + | You will also need the correct hardware to reprogram the boards. If you do not have a [http://evilmadscience.com/productsmenu/partsmenu/143-header 6-pin DIL header] installed on each Octolively/IGoL circuit board, you should add one at this time. You will also need an AVR ISP programmer that comes with a 6-pin ribbon cable, such as the [http://evilmadscience.com/productsmenu/tinykitlist/106-usbtiny USBtinyISP]. |