Editing Ostrich Eggbot Kit
Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.
The edit can be undone.
Please check the comparison below to verify that this is what you want to do, and then save the changes below to finish undoing the edit.
Latest revision | Your text | ||
Line 20: | Line 20: | ||
* Part II: [[Installing software]] (These instructions shared with [[The Original Egg-Bot Kit]].) | * Part II: [[Installing software]] (These instructions shared with [[The Original Egg-Bot Kit]].) | ||
* Part III: [[Making your first plot]] (These instructions shared with [[The Original Egg-Bot Kit]].) | * Part III: [[Making your first plot]] (These instructions shared with [[The Original Egg-Bot Kit]].) | ||
− | + | * Part IV: Fine tuning and aligning the Ostrich Eggbot | |
+ | :: To be added, late September | ||
Line 29: | Line 30: | ||
'''Hardware Reference Design''' | '''Hardware Reference Design''' | ||
− | * The Ostrich Eggbot is an open source hardware+software project. | + | * The Ostrich Eggbot is an open source hardware+software project. Hardware documentation will be posted in late September. |