Editing Breadboard Menorah Alternate Build
Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.
The edit can be undone.
Please check the comparison below to verify that this is what you want to do, and then save the changes below to finish undoing the edit.
Latest revision | Your text | ||
Line 12: | Line 12: | ||
* Instead of leaving one zero-ohm jumper straight, leave two straight | * Instead of leaving one zero-ohm jumper straight, leave two straight | ||
* Overall, you should have the following lengths of zero-ohm jumpers: 0.4", 0.5" (X4), 0.7" (X2), 1.8", straight (X2) | * Overall, you should have the following lengths of zero-ohm jumpers: 0.4", 0.5" (X4), 0.7" (X2), 1.8", straight (X2) | ||
− | * Construct a 0.2" jumper wire from the clipped lead of a 0.4" zero-ohm jumper or resistor | + | * Construct a 0.2" jumper wire from the clipped lead of a 0.4" zero-ohm jumper or resistor |
* Bend the 51 ohm resistor into a U-shape immediately after the resistor body and clip the leads to 0.3" long, like so: | * Bend the 51 ohm resistor into a U-shape immediately after the resistor body and clip the leads to 0.3" long, like so: | ||
<img src="http://shop.emscdn.com/wiki/bbmk/bbmk_alt3.png" height="56.5" width="225"> | <img src="http://shop.emscdn.com/wiki/bbmk/bbmk_alt3.png" height="56.5" width="225"> | ||
Line 34: | Line 34: | ||
<img src="http://shop.emscdn.com/wiki/bbmk/bbmk_alt5.png" height="167.5" width="71.5"> | <img src="http://shop.emscdn.com/wiki/bbmk/bbmk_alt5.png" height="167.5" width="71.5"> | ||
− | * Prepare a Red LED according to the procedure for the Yellow LED, instead twisting one zero-ohm jumper to each leg. | + | * Prepare a Red LED according to the procedure for the Yellow LED, instead twisting one zero-ohm jumper to each leg. On the long lead of the LED, place the body of the jumper slightly lower so that you can tell them apart. Insert from 55-a (long lead) to the blue stripe (short lead). |
'''In Step 5''' | '''In Step 5''' | ||
* The Yellow LED goes from 31-a to the blue stripe. | * The Yellow LED goes from 31-a to the blue stripe. |