Editing Creating filled regions
Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.
The edit can be undone.
Please check the comparison below to verify that this is what you want to do, and then save the changes below to finish undoing the edit.
Latest revision | Your text | ||
Line 92: | Line 92: | ||
Advantages: Can be applied to more than one object at once. Handles complex geometry. | Advantages: Can be applied to more than one object at once. Handles complex geometry. | ||
− | Disadvantages: Tedious to apply. Generates concentric paths that are not connected-- the pen must lift and lower between drawing any two inset shapes. Concentric paths cannot be adjusted in shape or space after being generated. Occasionally, if the inset shape becomes too complicated, the inset operation can fail. (The un-insettable path can usually be fixed by using the | + | Disadvantages: Tedious to apply. Generates concentric paths that are not connected-- the pen must lift and lower between drawing any two inset shapes. Concentric paths cannot be adjusted in shape or space after being generated. Occasionally, if the inset shape becomes too complicated, the inset operation can fail. (The un-insettable path can usually be fixed by using the "simplify path" command.) |