Editing ISP Shield Assembly Instructions
Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.
The edit can be undone.
Please check the comparison below to verify that this is what you want to do, and then save the changes below to finish undoing the edit.
Latest revision | Your text | ||
Line 168: | Line 168: | ||
=== 5. LEDs === | === 5. LEDs === | ||
− | There are four LEDs included | + | There are four LEDs included iwth the kit, that go in the locations labeled PROG, ERROR, PULSE, and HELLO. Orientation is important: the ''long lead'' goes into the ''square hole''. Solder them in place and clip the leads short. After inserting the LEDs but before soldering, you can bend the leads out at 45 degrees to hold an LED in place while you solder. |