Editing ISP Shield 2 Assembly Instructions
Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.
The edit can be undone.
Please check the comparison below to verify that this is what you want to do, and then save the changes below to finish undoing the edit.
Latest revision | Your text | ||
Line 169: | Line 169: | ||
http://shop.emscdn.com/wiki/ispshield/assy_v2/09.jpg | http://shop.emscdn.com/wiki/ispshield/assy_v2/09.jpg | ||
− | Once the header is lined up flip the board over and solder all the other five pins to the board. (You can solder all six from the bottom, but remember to start with one of the holes that isn't the square-pad one!) | + | Once the header is lined up flip the board over and solder all the other five pins to the board. (You can solder all six from the bottom, but remember to start with one of the holes that isn't the square-pad one!) The header pins on the back side are short enough that they do not need to be trimmed. |