Difference between revisions of "ISP Shield Assembly Instructions"
From Evil Mad Scientist Wiki
| Line 27: | Line 27: | ||
|---- | |---- | ||
|3 | |3 | ||
| − | |J5 ( | + | |J5 (jumper) |
|Target Power Enable, Jumper | |Target Power Enable, Jumper | ||
|2 pin jumper block, 0.1” spacing | |2 pin jumper block, 0.1” spacing | ||
| Line 108: | Line 108: | ||
|13 | |13 | ||
| n/a | | n/a | ||
| − | |||
|PCB for ISP Shield | |PCB for ISP Shield | ||
| + | |Printed circuit board | ||
|Evil Mad Science | |Evil Mad Science | ||
|681 | |681 | ||
Revision as of 00:20, 23 March 2011
Bill of Materials
| Line | Ref Des | Description | Type | Vendor | Vendor Part Number | Quantity |
| 1 | J1 thru J4 | Header set, 6-pin (2 pcs), 8-pin (2 pcs) | Stacking type header, 0.1” spacing | Evil Mad Science | 633 | 1 |
| 2 | J5 | Target Power Enable, Header | 3 pin right-angle header, 0.1” spacing | Digikey | TSW-103-25-F-SRA-ND | 1 |
| 3 | J5 (jumper) | Target Power Enable, Jumper | 2 pin jumper block, 0.1” spacing | Digikey | A26242-ND | 1 |
| 4 | S1 | Reset Switch | Tactile pushbutton switch | Digikey | 679-2452-ND | 1 |
| 5 | ISP6 | 6 pin ISP Header | 2x3 pin 0.1” spaced DIL header | Digikey | 609-3202-ND | 1 |
| 6 | R1 | Reset line pull-up resistor | 10k, 1/6 W | Digikey | 10KETR-ND | 1 |
| 7 | R2 thru R6 | Reset and LED load resistors | 1000 ohm, 1/4 W | Digikey | 1.0KQBK-ND | 5 |
| 8 | PROG, ERROR, PULSE, HELLO | Indicator LED | 3mm, Diffused Yellow | Evil Mad Science | 357 | 4 |
| 9 | C1 | Bypass Capacitor | 0.1uF Capacitor | Digikey | BC1148TR-ND | 1 |
| 10 | C2, C3 | Capacitors for crystal | 18pF, 50 V ceramic | Digikey | BC1004CT-ND | 2 |
| 11 | XTL | Crystal | 16 MHz | Digikey | XC1721-ND | 1 |
| 12 | U1 | ZIF Dip Socket | 28 pin, 0.3" pin spacing | Evil Mad Science | 212 | 1 |
| 13 | n/a | PCB for ISP Shield | Printed circuit board | Evil Mad Science | 681 | 1 |
