Difference between revisions of "Breadboard Menorah Alternate Build"
From Evil Mad Scientist Wiki
| Line 10: | Line 10: | ||
In step 3C | In step 3C | ||
* the switch goes in row i (instead of j) from 30 to 33 | * the switch goes in row i (instead of j) from 30 to 33 | ||
| + | |||
In step 4 | In step 4 | ||
* Prepare a Red LED by twisting one zero-ohm jumper to each leg, and insert from 55 a to the blue stripe | * Prepare a Red LED by twisting one zero-ohm jumper to each leg, and insert from 55 a to the blue stripe | ||
| + | |||
In Step 5 | In Step 5 | ||
* The Yellow LED goes from 31 a to the blue stripe | * The Yellow LED goes from 31 a to the blue stripe | ||
Revision as of 18:17, 17 November 2013
Alternate build notes for the breadboard menorah with the shamash on the end. Read through prior to bending any resistors or jumpers!
In Steps 2-3
- One of the 0.5” jumpers should be left straight and unclipped
- One more of the 0.5” jumpers should be made 0.7” instead and will go from 50 f to 55 c
- Use a clipped lead from one of the resistors (ideally from one trimmed to the 0.4” length) to make an extra 0.4” jumper (which will look like a staple) to go from 32 j to the lower blue stripe
- The 51 ohm resistor gets bent in a U-shape and goes from 31 c to 32 c
In step 3C
- the switch goes in row i (instead of j) from 30 to 33
In step 4
- Prepare a Red LED by twisting one zero-ohm jumper to each leg, and insert from 55 a to the blue stripe
In Step 5
- The Yellow LED goes from 31 a to the blue stripe
