Difference between revisions of "Breadboard Menorah Alternate Build"
From Evil Mad Scientist Wiki
(Created page with "Alternate build notes for the breadboard menorah with the shamash on the end * The 51 ohm resistor goes from 31 c to 32 c * The Yellow LED goes from 30 a to 30 blue stripe up...") |
|||
| Line 1: | Line 1: | ||
| − | Alternate build notes for the breadboard menorah with the shamash on the end | + | Alternate build notes for the breadboard menorah with the shamash on the end. Read through prior to bending any resistors or jumpers! |
| − | + | In Steps 2-3 | |
| − | * | + | * One of the 0.5” jumpers should be left straight and unclipped |
| − | * | + | * One more of the 0.5” jumpers should be made 0.7” instead and will go from 50 f to 55 c |
| − | * Use a clipped lead from one of the resistors (ideally from one | + | * Use a clipped lead from one of the resistors (ideally from one trimmed to the 0.4” length) to make an extra 0.4” jumper (which will look like a staple) to go from 32 j to the lower blue stripe |
| + | * The 51 ohm resistor gets bent in a U-shape and goes from 31 c to 32 c | ||
| − | |||
| − | |||
| − | * | + | In step 3C |
| + | * the switch goes in row i (instead of j) from 30 to 33 | ||
| + | |||
| + | In step 4 | ||
| + | * Prepare a Red LED by twisting one zero-ohm jumper to each leg, and insert from 55 a to the blue stripe | ||
| + | |||
| + | In Step 5 | ||
| + | * The Yellow LED goes from 31 a to the blue stripe | ||
Revision as of 18:17, 17 November 2013
Alternate build notes for the breadboard menorah with the shamash on the end. Read through prior to bending any resistors or jumpers!
In Steps 2-3
- One of the 0.5” jumpers should be left straight and unclipped
- One more of the 0.5” jumpers should be made 0.7” instead and will go from 50 f to 55 c
- Use a clipped lead from one of the resistors (ideally from one trimmed to the 0.4” length) to make an extra 0.4” jumper (which will look like a staple) to go from 32 j to the lower blue stripe
- The 51 ohm resistor gets bent in a U-shape and goes from 31 c to 32 c
In step 3C
- the switch goes in row i (instead of j) from 30 to 33
In step 4
- Prepare a Red LED by twisting one zero-ohm jumper to each leg, and insert from 55 a to the blue stripe
In Step 5
- The Yellow LED goes from 31 a to the blue stripe
