Breadboard Menorah Alternate Build

Alternate build notes for the breadboard menorah with the shamash on the end. Read through prior to bending any resistors or jumpers!

In Steps 2-3

• One of the 0.5” jumpers should be left straight and unclipped
• One more of the 0.5” jumpers should be made 0.7” instead and will go from 50 f to 55 c
• Use a clipped lead from one of the resistors (ideally from one trimmed to the 0.4” length) to make an extra 0.4” jumper (which will look like a staple) to go from 32 j to the lower blue stripe
• The 51 ohm resistor gets bent in a U-shape and goes from 31 c to 32 c

In step 3C

• the switch goes in row i (instead of j) from 30 to 33

In step 4

• Prepare a Red LED by twisting one zero-ohm jumper to each leg, and insert from 55 a to the blue stripe

In Step 5

• The Yellow LED goes from 31 a to the blue stripe