ISP Shield 2.0 Assembly Instructions

This page walks through the basic assembly process for building the ISP Shield 2.0.

Bill of Materials, or, "What's in the kit?"

Line	Ref Des	Description	Type	Vendor	Vendor Part Number	Quantity
1	n/a	PCB for ISP Shield 2.0	Printed circuit board	Evil Mad Science	681	1
2	R1	Reset line pull-up resistor	10k, 1/6 W	Digikey	10KETR-ND	1
3	R2 thru R6	Reset and LED load resistors	1000 ohm, 1/4 W	Digikey	1.0KQBK-ND	5
4	R7	Auto-reset overrride resistor	100 ohm, 1/4 W	Digikey	100QBK-ND	1
5	J5, J6	Target Power Enable, Auto-Reset Overrride (Header)	6 pin right-angle header, 0.1” spacing	Digikey	SAM1043-06-ND	1
6	PROG, ERROR, PULSE, HELLO	Indicator LEDs	3mm, Diffused Yellow	Evil Mad Science	357	4
7	XTL	Crystal	16 MHz	Digikey	XC1721-ND	1
8	C2, C3	Capacitors for crystal	18pF, 50 V ceramic	Digikey	BC1004CT-ND	2
9	C1	Bypass Capacitor	0.1uF Capacitor	Digikey	BC1148TR-ND	1
10	S1	Reset Switch	Tactile pushbutton switch	Digikey	679-2452-ND	1
11	ISP6	6 pin ISP Header	2x3 pin 0.1” spaced DIL header	Digikey	609-3202-ND	1
12	J1 thru J4	Header set, 6-pin (2 pcs), 8-pin (2 pcs)	Stacking type header, 0.1” spacing	Evil Mad Science	633	1
13	U1	ZIF DIP Socket	28 pin, 0.3" pin spacing	Evil Mad Science	212	1
14	J5, J6 (jumper)	Target Power Enable, Auto-Reset Override (Jumper)	2 pin jumper block, 0.1” spacing	Digikey	A26242-ND	2

Assembly procedure

We'll go line by line through the kit components. This guide assumes that you have had some soldering experience. If not, or it's been a while, you may also want to look at pages 2 and 5-7 of the Bulbdial clock assembly instructions, which go over basic tools and technique. And, if you really are a beginner, there are plenty of good tutorials on line, like this one.

(Instructions coming soon!)