Editing Breadboard Menorah Alternate Build
Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.
The edit can be undone.
Please check the comparison below to verify that this is what you want to do, and then save the changes below to finish undoing the edit.
Latest revision | Your text | ||
Line 1: | Line 1: | ||
− | + | Alternate build notes for the breadboard menorah with the shamash on the end. Read through prior to bending any resistors or jumpers! | |
− | + | In Step 2 | |
+ | * One of the 0.5” jumpers should be left straight and unclipped | ||
+ | * One more of the 0.5” jumpers should be made 0.7” instead | ||
+ | * Use a clipped lead from one of the resistors (ideally from one trimmed to the 0.4” length) to make an extra 0.4” jumper (which will look like a staple) | ||
+ | * The 51 ohm resistor gets bent in a U-shape | ||
− | |||
+ | In step 3C | ||
+ | * the switch goes in row i (instead of j) from 30 to 33 | ||
− | + | In step 3E | |
− | * | + | * The extra 0.7” jumper goes from 50 f to 55 c |
− | + | * Use extra 0.4” jumper goes from 32 j to the lower blue stripe | |
− | * | + | * The 51 ohm resistor goes from 31 c to 32 c |
− | |||
− | |||
− | * | ||
− | |||
+ | In step 4 | ||
+ | * Prepare a Red LED according to the Yellow LED instructions, but instead twisting one zero-ohm jumper to each leg. On the long lead, place the body of the jumper slightly lower so that you can tell them apart. Insert from 55 a (long lead) to the blue stripe (short lead). | ||
− | + | In Step 5 | |
− | + | * The Yellow LED goes from 31 a to the blue stripe | |
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | * The Yellow LED goes from 31 |