Editing Breadboard Menorah Alternate Build
Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.
The edit can be undone.
Please check the comparison below to verify that this is what you want to do, and then save the changes below to finish undoing the edit.
Latest revision | Your text | ||
Line 3: | Line 3: | ||
==Instruction changes for building the breadboard menorah with the shamash on the end.== | ==Instruction changes for building the breadboard menorah with the shamash on the end.== | ||
− | The notes below outline the changes to the printed instructions ([http://shop.emscdn.com/KitInstrux/breadboard-menorah-instrux- | + | The notes below outline the changes to the printed instructions ([http://shop.emscdn.com/KitInstrux/breadboard-menorah-instrux-c.pdf PDF Version] 1.3 MB) needed in order to build the breadboard menorah with the shamash on the end rather than in the middle. Please read all the way through prior to bending or clipping any resistors or jumpers! |
Line 23: | Line 23: | ||
<img src="http://shop.emscdn.com/wiki/bbmk/bbmk_alt6.png" height="279" width="810"> | <img src="http://shop.emscdn.com/wiki/bbmk/bbmk_alt6.png" height="279" width="810"> | ||
− | |||
* Place the 51 ohm resistor from 31-c to 32-c | * Place the 51 ohm resistor from 31-c to 32-c | ||
− | * Connect | + | * Connect 0.2" jumper wire from 30-h to 32-h |
* Place the second 0.7” jumper from 50-f to 55-c | * Place the second 0.7” jumper from 50-f to 55-c | ||