Difference between revisions of "Googly Assembly Instructions"
From Evil Mad Scientist Wiki
(CREATE) |
(No difference)
|
Revision as of 18:02, 25 November 2011
This page walks through the process of assembling the Googly Eye Shield for Arduino.
Bill of Materials, or, "What's in the kit?"
Line | Ref Des | Quantity | Description | Type | Vendor | Vendor Part Number |
1 | n/a | 1 | PCB for ISP Shield 2.0 | Printed circuit board | Evil Mad Science | 60-0030 |
2 | J1 thru J4 | 1 | Header set, 6-pin (2 pcs), 8-pin (2 pcs) | Stacking type header, 0.1” spacing | Evil Mad Science | 633 |
3 | n/a | 4 | Glue dot | 3/16" Diameter | Oriental Trading | 73/10034 |
4 | n/a | 2 | Googly Eye, large | 15 mm diameter | Micheals | 400100231388 |
4 | n/a | 2 | Googly Eye, small | 8 mm diameter | Micheals | 400100231050 |
Assembly procedure
We'll go line by line through the kit components. This guide assumes that you have had some soldering experience. If not, or it's been a while, you may also want to look at pages 2 and 5-7 of the Bulbdial clock assembly instructions, which go over basic tools and technique. And, if you really are a beginner, there are plenty of good tutorials on line, like this one.