Editing Simple Relay Shield Assembly v2
Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.
The edit can be undone.
Please check the comparison below to verify that this is what you want to do, and then save the changes below to finish undoing the edit.
Latest revision | Your text | ||
Line 50: | Line 50: | ||
=== 1. Install the two 1k ohm resistors === | === 1. Install the two 1k ohm resistors === | ||
− | http://shop.emscdn.com/wiki/relayshield/ | + | http://shop.emscdn.com/wiki/relayshield/assy_v1/2.jpg |
The 1k ohm resistors will be installed in location R1 and R2. Shown here: | The 1k ohm resistors will be installed in location R1 and R2. Shown here: | ||
− | http://shop.emscdn.com/wiki/relayshield/ | + | http://shop.emscdn.com/wiki/relayshield/assy_v1/3.jpg |
Line 100: | Line 100: | ||
http://shop.emscdn.com/wiki/relayshield/assy_v2/12.jpg | http://shop.emscdn.com/wiki/relayshield/assy_v2/12.jpg | ||
+ | |||
+ | |||
=== 2. Install the two diodes === | === 2. Install the two diodes === |