Editing Snap-O-Lantern Kit Assembly Instructions
Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.
The edit can be undone.
Please check the comparison below to verify that this is what you want to do, and then save the changes below to finish undoing the edit.
Latest revision | Your text | ||
Line 62: | Line 62: | ||
The third zero-ohm jumper connects the left-most prototyping column to VCC_3 directly to the right. Connect the final jumper from the middle prototyping column to GND_3, also directly to the right. | The third zero-ohm jumper connects the left-most prototyping column to VCC_3 directly to the right. Connect the final jumper from the middle prototyping column to GND_3, also directly to the right. | ||
− | Finally, install the 6-pin DIL header with one pin in each of the top two prototyping rows and across the first two columns. | + | Finally, install the 6-pin DIL header with one pin in each of the top two prototyping rows and across the first two columns. |
+ | |||
== Battery box and microcontroller == | == Battery box and microcontroller == | ||
Line 70: | Line 71: | ||
Connect the red wire from the battery box to VCC_IN+. Connect the black wire to GND_IN. You can use the holes that would have been for a jack to provide strain relief for the battery box wires. | Connect the red wire from the battery box to VCC_IN+. Connect the black wire to GND_IN. You can use the holes that would have been for a jack to provide strain relief for the battery box wires. | ||
− | The final step for assembly of the electronics is to insert the microcontroller into its socket | + | The final step for assembly of the electronics is to insert the microcontroller into its socket. Orientation is critical: Make sure that the half-moon indentation at one end of the chip matches that on the socket and PCB. Insert it firmly, as far down into the socket as it will go. |
+ | |||
== Servo motor setup and testing == | == Servo motor setup and testing == |