Editing AYAB KH-910
Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.
The edit can be undone.
Please check the comparison below to verify that this is what you want to do, and then save the changes below to finish undoing the edit.
Latest revision | Your text | ||
Line 60: | Line 60: | ||
<img src="http://cdn.evilmadscientist.com/wiki/ayab/installation/910-disconnect@2x.jpg" width="800" height="425" > | <img src="http://cdn.evilmadscientist.com/wiki/ayab/installation/910-disconnect@2x.jpg" width="800" height="425" > | ||
− | Disconnect all of the cables that connect the circuit board inside this cover to the rest of the machine. | + | Disconnect all of the cables that connect the circuit board inside this cover to the rest of the machine. These connectors have locking clip "wings" on their edges. You will have to squeeze the clips as shown above to disconnect them. |
If you are opening up the machine for the first time (in 30 years?) you may find that the cables are a bit stiff. It's okay to pull a little extra slack out on the cables to make access easier. | If you are opening up the machine for the first time (in 30 years?) you may find that the cables are a bit stiff. It's okay to pull a little extra slack out on the cables to make access easier. |