Creating filled regions
Hatch Method
This method is described in detail in our smiley face tutorial.
In short:
- Select a single path
- Open the live path effect editor: Path>Path Effect Editor
- Apply new effect: Hatches (rough) and click "+Add"
- Use the extension to set defaults: Extensions>Eggbot>Preset hatch for fills
- Use the "edit paths by node" tool to set the angle, spacing, and bending of the lines.
You may also need to use the Fill & Stroke panel to set the stroke to be a visible pen and the fill to "none."
This "Hatch" method can handle paths that consist of multiple disjoint regions, for example, a set of stars or non-intersecting circles, but it does not work with "hollow" regions, for example a ring or washer (2D torus) shape.
While it is slightly complicated and does not work in every situation, it's usually the best method in any situation where it can be used. It produces excellent results that plot very smoothly and efficiently, with preset deceleration at each switchback and an absolute bare minimum of pen lifts.
Inset Method
Path > Inset
Interpolation method
Generate from path> Interpolate
http://inkscape.org/doc/interpolate/tutorial-interpolate.en.html
Stitch method
Combine paths Live path effects> Stitch sub-paths
Combining methods
http://inkscape.org/doc/interpolate/tutorial-interpolate.en.html
