Editing Name Poem
Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.
The edit can be undone.
Please check the comparison below to verify that this is what you want to do, and then save the changes below to finish undoing the edit.
| Latest revision | Your text | ||
| Line 20: | Line 20: | ||
To use the extension, enter each line of text in one of the twelve text input fields, "Line 1", "Line 2", etc. Note that consecutive blank lines will be replaced with a single blank line when drawn. The first character of each line will be drawn using the "Leading font" selection. The remaining text in each line will be drawn using the "Secondary font". These fonts are the same fonts used with the Hershey Text extension under the Render category of extensions. | To use the extension, enter each line of text in one of the twelve text input fields, "Line 1", "Line 2", etc. Note that consecutive blank lines will be replaced with a single blank line when drawn. The first character of each line will be drawn using the "Leading font" selection. The remaining text in each line will be drawn using the "Secondary font". These fonts are the same fonts used with the Hershey Text extension under the Render category of extensions. | ||
| − | To account for the horizontal compression which occurs when plotting on eggs, select the "Stretch the text horizontally..." checkbox. That will horizontally stretch the text by 50% [2]. | + | To account for the horizontal compression which occurs when plotting on eggs, you can select the "Stretch the text horizontally..." checkbox. That will horizontally stretch the text by 50% [2]. |
To rotate the text 180 degrees turning it upside down, check the "Plot with the egg's bottom at the egg motor?" checkbox. You do not need to use this option if you have reversed the motion of both motors in the Options tab of the Eggbot Control extension. | To rotate the text 180 degrees turning it upside down, check the "Plot with the egg's bottom at the egg motor?" checkbox. You do not need to use this option if you have reversed the motion of both motors in the Options tab of the Eggbot Control extension. | ||
